Phnom Penh, serving Cambodia and the region

Glossary

Leak rate

The share of a compressed air system's output lost through leaks, usually expressed as a percentage of compressor capacity or as a flow when production is stopped.

Leak rate is measured when production is idle: the compressors then supply only leaks and fixed losses, so their loaded time or a flow meter shows the leak load directly. It can also be estimated from the time a known receiver volume takes to drop between two pressures.

The US Department of Energy notes that leaks can waste 20-30% of a compressor’s output, that a poorly maintained plant may have a leak rate around 20% of its production capacity, and that proactive leak management can bring this to well under 10%.

Leaks cost energy around the clock, lower system pressure and drive operators to raise set-points, which increases artificial demand. Measure the rate, find leaks with ultrasonic leak detection, repair, then measure again. Treat it as a routine KPI rather than a one-off campaign.

Next step

Need this applied to your plant?

We turn definitions into specifications, then into equipment that meets them.

Start typing to search