Under load/unload control, a fixed-speed screw compressor loads (inlet valve open, full delivery) until pressure reaches the upper set point, then unloads (inlet closed, blow-down) while the motor keeps turning. When pressure falls to the lower set point it loads again. If unloaded for long enough, the controller stops the motor.
It is simple and reliable, and ideal for a machine that stays loaded. When demand varies, though, the machine spends long periods unloaded, drawing power without delivering air.
Practical note: receiver volume governs how often the machine cycles. Too little storage causes short cycles, motor starts and wasted blow-down energy. Logging load and unload hours is the quickest first look at whether a VSD or better sequencing would pay.