Phnom Penh, serving Cambodia and the region

AirMaxRTO for VOC destruction

AirMax regenerative thermal oxidisers (RTO)

Fully automatic RTOs that destroy VOCs by high-temperature oxidation and recover most of the heat in ceramic beds.

Spec summary

At a glance

TypeRTO for VOC destruction
Flow / capacity (FAD)Typically ≈10,000–200,000 CMH; depends on the application
EfficiencyTypically ≈95–99 % destruction efficiency; depends on the compounds and operating conditions

Indicative. Confirm against the current manufacturer datasheet.

Key features

  • High-temperature oxidation of VOCs to carbon dioxide and water vapour
  • Ceramic heat-exchange beds recover heat to preheat incoming air
  • Fully automatic operation with PLC control and safety interlocks
  • Can run with little or no auxiliary fuel at sufficient VOC concentration
  • Low emissions at the stack
  • Can treat the concentrated stream from a zeolite rotor

Applications

  • Coating and laminating ovens
  • Printing exhaust
  • Chemical process vents
  • Paint shops, often downstream of a rotor concentrator

Destroy the VOCs, recover the heat

A regenerative thermal oxidiser (RTO) destroys volatile organic compounds by heating the exhaust to a high temperature, where they oxidise to carbon dioxide and water vapour. What makes it regenerative is heat recovery: ceramic beds capture the heat of the outgoing clean air and use it to preheat the incoming dirty air. That makes thermal oxidation economical where it would otherwise burn a great deal of fuel.

AirMax RTOs are fully automatic. Typical airflows range from about 10,000 to 200,000 CMH, and typical destruction efficiency is in the region of 95 to 99 %. Both depend on the application. We state expected performance for your exhaust after characterisation.

How it works

An RTO has two or more chambers filled with ceramic media, connected through a combustion chamber at the top. Dirty air enters through a hot bed, which preheats it. In the combustion chamber, a burner holds the temperature needed for oxidation. Hot, clean air then leaves through a second bed, which absorbs its heat. Valves periodically switch the flow direction, so the bed that was absorbing heat now preheats the incoming air.

At high enough VOC concentrations, the heat released by oxidising the VOCs keeps the chamber at temperature with little or no burner fuel. At low concentrations, a zeolite rotor concentrator upstream can raise the concentration and shrink the airflow.

Where it fits

  • Coating, laminating and drying ovens.
  • Printing exhaust.
  • Chemical process vents.
  • Paint shops, with or without a rotor concentrator.

Selection notes

  • Concentration drives running cost. Very dilute exhausts need more burner fuel. We model fuel use from your concentration and airflow.
  • Particulates and silicones. Dust, overspray and some compounds, such as silicones, foul ceramic media. Pre-filtration and a compound review protect it.
  • Corrosive products. Chlorinated or sulphur-bearing compounds form acid gases when oxidised, which may require a scrubber downstream.
  • Safety. Concentrations are kept well below flammable limits by design, with interlocks, monitoring and purge sequences.
  • Heat recovery. Surplus heat can sometimes be recovered for process use.

What Nexus provides

Exhaust characterisation, RTO selection and system design with ducting, fans, controls and safety systems, installation and commissioning with performance testing, and planned maintenance of valves, burners, media and instruments.

Next step

Request a quote for AirMax regenerative thermal oxidisers (RTO)

Send your operating data and we will size and propose the right configuration.

Start typing to search