Phnom Penh, serving Cambodia and the region

Glossary

Desiccant dryer

A compressed air dryer that removes water vapour by adsorption onto a desiccant bed, reaching pressure dew points of -40 °C or -70 °C.

A desiccant (adsorption) dryer passes air through a tower of desiccant such as activated alumina or molecular sieve, while a second tower regenerates. Typical design points are a pressure dew point of -40 °C (ISO 8573-1 water Class 2) or -70 °C (Class 1).

Plants use them where moisture must never condense: pharmaceutical and food contact air, electronics, outdoor lines and nitrogen generator feed.

Regeneration is the running cost. Heatless designs use a share of the dried air as purge; manufacturers commonly quote roughly 15-20% of rated flow. Heated and blower-purge designs use less compressed air but add heater energy. Protect the bed with a coalescing filter upstream, because oil aerosol fouls desiccant permanently, and fit dew-point-dependent switching so the dryer does not purge more than the load requires.

Next step

Need this applied to your plant?

We turn definitions into specifications, then into equipment that meets them.

Start typing to search